H∞ control for uncertain one‐sided Lipschitz nonlinear systems in finite frequency domain

The current article discusses the H_∞ disturbance attenuation control design problem for one‐sided Lipschitz systems in finite frequency domain. Models containing norm‐bounded parameter uncertainties, disturbances, and input nonlinearities are considered. By contrast to existing full frequency methods, the H_∞ controller is computed depending on the frequency ranges of disturbances. The finite frequency disturbance attenuation index is initially defined. Thanks to Finsler's lemma, sufficient and less conservative analysis conditions are also derived for the closed‐loop system. Then, synthesis conditions in the low, middle, and high frequency ranges as well as the whole frequency range, are formulated in terms of linear matrix inequalities. At last, to prove the effectiveness and the superiority of the proposed approach, a physical example is used and a comparative study is done.     

复频电导技术在隧洞超前探水中的应用

围岩富水带是隧道超前预报最关注的问题，目前，多使用电磁方法来预报围岩的含水性，但受到场地条件限制，面临掌子面条件、金属机具干扰、三维波场定位等诸多困难，特别是掌子面前方100 m范围内围岩的含水性预报，在国内外都是一个新的高难课题。在研究了岩体电导率与电容率复频特性的基础上，结合巴基斯坦NJ-TBM引水隧洞工程，开发了复频电导探水(CFC)技术。该技术基于电磁波反射与相干原理，选用100 kHz～10 MHz频率范围，采用电偶极子发射与阵列接收方式和偏移成像技术，突破了隧道内场地条件的限制。依据1/4相干波长确定含水体的位置，相干能量确定含水量的大小。在巴基斯坦NJ-TBM隧洞超前探水的应用，证明了该方法的可行性与有效性。      

基于ARM7的高精度频率计的设计

文章通过对相位重合检测技术的分析，提出了基于此理论并用ARM7作为主控芯片的高精度频率计的设计方法。该设计方法通过捕捉相位之间的重合点，能够有效消除±1个字的计数误差。在此基础上由于ARM7具有32位的处理器内核以及流水线技术，使得频率计的测量速度和精度比传统的使用16位单片机设计的频率计要高很多。本频率计最大测量频率为10MHz。同时本设计采用安捷伦公司生产的恒温晶振10811A作为标准频率，能够有效保证测量精度能够达到10-10量级。为了降低成本，在设计中选用采用ARM7芯片内部的计数器以及用简单的逻辑电路进行设计。由于其测量精度要超过多周期同步测量法，而成本又比模拟内插法和游标法低很多，因此此频率计拥有很广泛的市场前景。     

低觉醒脑电识别与唤醒的可穿戴系统研究

为智能化地识别警戒作业人员出现的低觉醒、注意力下降的生理状态，本文介绍了一种基于FPGA和脑电信号处理的低觉醒状态检测与唤醒系统，系统通过传感器从大脑头皮采集脑电信号，转换为数字信号，经傅里叶变换获取了脑电信号的θ相对能量、α相对能量、重心频率、谱熵等4个特征量，由4个特征量表征低觉醒状态并运用支持向量机对低警戒状态进行识别，当识别出低觉醒状态时采用声音报警模块发出声音，唤醒警戒作业人员。设计系统能够较好地识别出低觉醒状态，识别率达90.8%，可为提高警戒作业工作绩效提供一种可穿戴的智能装备。     

长期演进系统基于加权平均时延的下行资源调度

针对长期演进（LTE）移动通信系统下行链路传输中多用户的实时（RT）与非实时（NRT）业务传输性能需求问题，提出一种基于用户加权平均时延的改进型的最大加权延时优先（MLWDF）资源调度算法。该算法在考虑信道感知与用户服务质量（QoS）感知的基础上引入反映用户缓冲区状态的加权平均时延因子，该因子通过用户缓冲区中待传输数据与已发送数据的平均时延均衡得到，使具有较大时延和业务量的实时业务优先调度，提升了用户的性能体验。理论分析与链路仿真表明，提出算法在保证各业务时延及公平性的基础上，提升了实时业务的QoS性能，在用户数量达到50的条件下，对比MLWDF算法实时业务的丢包率降低了53.2%，其用户平均吞吐量提升了44.7%，虽牺牲了非实时业务的吞吐量，但仍优于VT-MLWDF算法。实验结果表明，所提算法在多用户多业务传输条件下提升了实时业务的传输性能，并在QoS性能上明显优于对比算法。     

When is it reasonable to implement the discontinuous sliding‐mode controllers instead of the continuous ones? Frequency domain criteria

Professor Utkin proposed an example showing that the amplitude of chattering caused by the presence of parasitic dynamics (stable actuators) in some systems governed by the First‐Order Sliding‐Mode Controller is lower than that produced by the Super‐Twisting Algorithm. This example served to motivate this paper reconsidering the problem of comparison of chattering in systems with stable actuators, and driven by Discontinuous Sliding‐Mode Controllers (DSMCs) and Continuous Sliding‐Mode Controllers (CSMCs). Comparison of chattering produced by DSMC and CSMC taking into account their amplitudes, frequencies, and average power (AP) needed to maintain the system into real‐sliding modes, allowing to conclude the following: (i) for systems with slow actuators, the amplitude of oscillations and AP produced by DSMC be smaller than those caused by CSMC; (ii) for bounded disturbances with fixed Lipschitz constant, there exist sufficiently fast actuators for which the amplitude of oscillations and AP produced by CSMC be smaller than those caused by DSMC.     

基于紧耦合结构的宽带基站天线设计

随着5G移动通信频段的公布,传统基站天线已不足以覆盖其工作频段。文章以紧耦合阵列天线理论为基础,提出了一种基于紧耦合结构的交叉偶极子宽带基站天线。该天线由两对正交的领结状偶极子天线构成,通过两对交叉偶极子之间的耦合效应,有效地展宽了天线的阻抗带宽。同时,通过在天线和金属反射板之间加载电阻型频率选择表面,吸收由反射板引入的谐振反射波,改善天线高频端辐射性能。仿真及测试结果表明:该天线在1.7-3.6 GHz 频率范围内,可以满足基站天线的设计指标,两端口驻波比均小于1.5,两端口之间隔离度大于55 dB,半功率波束宽度满足65°±5°范围,且整个频段内增益均大于8.5 dBi。     

Generation-expansion planning with linearized primary frequency response constraints

As renewable energy resources increasingly penetrate the electric grid, the inertia capability of power systems has become a developmental bottleneck. Nevertheless, the importance of primary frequency response (PFR) when making generation-expansion plans has been largely ignored. In this paper, we propose an optimal generation-expansion planning framework for wind and thermal power plants that takes PFR into account. The model is based on the frequency equivalent model. It includes investment, startup/shutdown, and typical operating costs for both thermal and renewable generators. The linearization constraints of PFR are derived theoretically. Case studies based on the modified IEEE 39-bus system demonstrate the efficiency and effectiveness of the proposed method. Compared with methods that ignore PFR, the method proposed in this paper can effectively reduce the cost of the entire planning and operation cycle, improving the accommodation rate of renewable energy.     

铸造式和焊接式主轴箱体的动态特性对比分析

利用有限元法和试验模态法对立式加工中心的铸造式和焊接式两种结构的主轴箱体进行了模态分析,分别获得了其前六阶固有频率和振型。通过对比两种方法获得的结果,验证了有限元分析模型的有效性。研究表明,两种主轴箱体的阻尼比接近,但焊接式主轴箱体的各阶固有频率均要高于铸造式主轴箱体的各阶固有频率。并且铸造式主轴箱体的固有频率更接近于机床主轴的常用工作频率,焊接式主轴箱体的则远离此频率。因此对于常用主轴转速而言,焊接式主轴箱体的动态性能要优于铸造式主轴箱体的动态性能。